1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

K&N 63-1058 installation question

Discussion in 'Performance and Tuning' started by Psivector, Jun 4, 2017.

  1. Jun 4, 2017 at 8:20 PM
    #1
    Psivector

    Psivector [OP] New Member

    Joined:
    Jun 4, 2017
    Member:
    #8005
    Messages:
    2
    Gender:
    Male
    Vehicle:
    2004 toyota tundra limited
    Cold air Intake Borla Exhaust system
    Hi all, I have a 2004 Toyota Tundra Limited and I recently bought the 63-1058 cold air intake system and it came with two hoses. My question is what purpose do they serve if any? When I drive my engine doesnt overheat or have issues but I would like to follow the manual as much as possible.

    Attached is half of the image im trying to reference. They are parts G E and F. I recieved only two hoses bear in mind.

    Thank you in advance.

    Screenshot_2017-06-04-22-18-25.jpg
     
  2. Jun 4, 2017 at 9:10 PM
    #2
    duece292

    duece292 Appalachian American

    Joined:
    Mar 13, 2017
    Member:
    #6776
    Messages:
    1,884
    Gender:
    Male
    First Name:
    Greg
    Green Bay, WI
    Vehicle:
    2013 Tundra SR5 CM TRD 5.7 4X4
    Welcome! According to the installation instructions it looks like you should have all 3 hoses. Not sure what all 3 are for, I would think that one is a crank case breather, the other two?? Probably some kind of vent lines. In any case you're going to want those. They're supplied because the stock lines are usually too short to be reused. You should also make sure that the fittings that thread into the intake tube are there as well. You'll need those to connect the hoses. If it's only one hose that you're missing I'm sure you can get it from K&N but the quicker route is to hit an auto parts store that carries bulk vacuum hose and pick up a foot or so of the correct size. K&N's specification is inside diameter.
     
  3. Jun 15, 2017 at 12:20 PM
    #3
    Psivector

    Psivector [OP] New Member

    Joined:
    Jun 4, 2017
    Member:
    #8005
    Messages:
    2
    Gender:
    Male
    Vehicle:
    2004 toyota tundra limited
    Cold air Intake Borla Exhaust system
    Sorry for the late reply. I appreciate the advice i went to my local O Reillys and they cut a hose for me.
     

Products Discussed in

To Top