Baja Squadron SAE (square) to Tundra wiring harness/adapter?

Searched but keep coming up with results for the direct-fit lights.

I have the square, non-Tundra-specific Baja Designs Squadron SAE fogs for my aftermarket bumper and am trying to sort out what I need to make them replace my OE fogs wiring-wise.

Any help? Thanks!

 

@Baja Designs

 

Boom! I was just in this same boat. Quick and easy.

$18 Cali Raised LED Tacoma, Tundra, and 4Runner Fog Light Pod H11 OEM Adaptor

https://www.amazon.com/gp/product/B06W5XCF9P?ie=UTF8

What bumper did you get?

 

Okay, I'm clearly an idiot. Looking at the pins on that adapter and then the lights. I think I'm missing something. Maybe I haven't had enough coffee yet.

Took a chance on the new ICI aluminum bumper. We shall see!

 

I just made my own.

$14 JRready ST6112 DT Connector 2 Pin Gray Waterproof Electrical Wire Connector DT04-2P DT06-2S with Deutsch Solid Contacts 14-20 AWG and Sealing Plugs,3 Sets

https://www.amazon.com/JRREADY-Conn...ctors&qid=1639067413&s=automotive&sr=1-8&th=1

 

Should just be plug and play.

I used these with my Rigid SAEs on ironman bumper.

 

My lights have round pins. Again, I'm probably missing something simple.

 

Those adapters have round pin heads to go into your fog and the factory style on the other end to plug into your factory fog harness.

 

These are the ends on the Baja side. The first pic is the end of the harness I'm not using, the second is the pigtail on the light.

 

$9 MUYI 10 Kit 2 Pin Waterproof Connector for 20-14 AWG Wire Harness 2.5mm Series Automotive Electrical Plugs with Replacement Terminal Pins Sockets and Spudger

https://www.amazon.com/MUYI-Waterpr...ctors&qid=1639068752&s=automotive&sr=1-3&th=1
These are compatible with the BD connectors. I cut the OEM off and used these to retain the fog light switch on the stalk. I also double checked to be sure the OEM wires were sufficient to run BD squadrons.

 

I think I have everything to cut and set up the adapters I bought, just surprised I have to.

 

Ah ok, guess the BD is a different style. You will have to do some chopping or find another premade harness on Amazon for that style.

 

I have adapters just like yours and the BD head and some pins the lights came with. Hopefully cutting the bad end and adding those works okay.

 

It should if you just solder the necessary wires.

 

I have these crimpers, they're not the best but they're invaluable for properly crimping the terminals. I also solder my wires to the pins but that's not 100% necessary.

 

Well, my stop-gap was to splice together the Amazon harness I got with the one the lights came with. After blowing 3 fuses, I got the polarity correct and I'm set until I can get some real ones..... if Baja Designs ever respond to me!