Installing heated seats

Hey y’all! I was wanting to know if I could wire up some heated seats in a 2008 that does currently not. It’s an sr5 with leather seats with no seat heaters as of now. I know a lot of things are pre wired into these trucks like lights, mirror workings, and trailer brake controllers to name a few. Therefore I was wanting to know if these were too. Any help?

 

I have an SR5 that did not have heated seats from the factory but the previous owner installed heated seats. Not sure if they are pre-wired for this but it can be done.

 

I did it with a kit I bought online. Took about 4 hours and a Dr Pepper. So far they work great and except for one nearly insignificant detail the switches look and perform like OE. Total cost was around 115.00

 

Pricing may not be at your intentions, but Katzkins
Custom Leather Seat Covers, Leather Seats, & Auto Interiors | Katzkin

 

Thank all y’all!

 

Do you by chance have a link to this kit? Just want to be sure that the one I get works correctly. Also, I love the Dr Pepper part

 

This is the one. I bought mine on a different site but it is not available there right now. This is the kit I bought though. Looks like you'll save money. Mine was 20.00 more before shipping/tax https://www.ebay.com/itm/173119731051

 

Pretty sure I have identical kit and it works great 2 years later.

 

Thank y’all again!

 

Nuther question, do I need to get new seats to do this? My leather seats are kinda rough looking and thinking about seeing if I could get some 1794 seats. However, if I absolutely needed to put them in the old seats how would I do that? Do I need to take the leather off or what? Video or instructions would be helpful.

 

I process of doing seats- I have cloth in pretty good shape that don’t want to take apart. The pads have a really sticky tape that I’m putting directly on the fabric and then covering the seats with the wet okole seat covers.
From my perspective - these are made in China and if one fails, I don’t want to have to redo the tear apart and install process over. Plus I like the wet okoles. The switch for the temp has already failed and is being replaced - ugh China parts.

For the wiring the harness -I joined the 2 power wires (each has a 15a fuse) wired them to a add a fuse to the “power seats” slot (30a) in kick panel. IIRC - For the “on- off” I did the same but put them on the “sun roof” slot because it is off accessory side-
Okoles should be here in a week or so.

 

Maybe this video might help:

 

I purchased this kit for my 18 tundra and I’m a little confused with my wiring. Kit came with black ground, yellow, red and another red with a 15amp fuse to connect to battery. How should I do this wiring?