1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

air injection valve plate orientation

Discussion in '2nd Gen Builds (2007-2013)' started by WISC, May 26, 2021.

  1. May 26, 2021 at 6:29 PM
    #1
    WISC

    WISC [OP] New Member

    Joined:
    May 26, 2021
    Member:
    #63554
    Messages:
    1
    Gender:
    Male
    I swapped out my secondary air injection valves due to a p2440 code. I must have got the valve plates disoriented. I have seen them oriented a few different ways on the internet. Therefore, I am confused about which way they fit. I did just replace the valve not the entire assembly. Which is the correct way A,B,C, or D? thank you.

    I have a 2011 Tundra 5.8L.
    Does orientation change between the left and right side?

    Valve A.jpg
    Valve B.jpg
    valve C.jpg

    Valve D.jpg
     
    Last edited: May 26, 2021

Products Discussed in

To Top