Rockford DSR1 Help Needed

ive got a JL 5 ch amp installed with JL door speakers, removed fix86 and replaced it with DSR1 along with Toyota T Harness. But now there is no audio from door speakers. I can hear some radio noise come from the subs, I unplugged the sub rcas from dsr to amp for now.

I tried adjusting gains and crossx on amp but audio.

I don’t have anything connected to the high level inputs that are on the harness since I’m using the cam bus connectors from factory amp.

Speaker config has not changed, the JL audio amp config has not changed. The only change is the dsr1.

Any assistance would be appreciated.

 

I updated the firmware again and reflashed to Toyota specific, but still no audio.

I plugged the factory amp back in and I get audio in dash speakers.

I’m at a loss?

 

Email james at tech12volts and see what he says tech12volt@gmail.com
give him as much information as you can (jbl, factory head unit....) and maybe include a pic of what inputs you are using with the dsr1.

 

Did you buy the dsr1 already set up? You could plug it into the computer or connect through the app and make sure its set up for the T harness and that the speaker config is correct.

 

This could be a ton of things but here are a few off the top of my head to check:

• Since you’re using it only rcas make sure low level input is selected on the amp for all inputs
• If doors are off do a continuity check from amp to speaker terminal. If not do a quick double check of your dsr1 to amp wiring. Make sure all connectors are plugged in fully as people have received bad T harnesses
  
• Check to make sure amp input for door rcaS is on high pass (Or all pass) filter. Go through dsr1 setting that make sure that is also selected for high pass (or all pass) filter.
  
• If dash speakers are working; confirm door tweeters are working too. They’re wired together. Or was this altered when you installed your speakers?