What have you done to your 2nd gen Tundra today?

I have a set of those...you're gonna love them!

 

You can give us a sneak peak.

 

Your right, how rude of me. Here you are sir

 

@Mountun Goat dude I have the same ones!!

 

@Prostar 190 @TG705

 

Just another treat to help out with the lights

 

morimoto leds (headlights/foglights)!

 

Finally was able to get my RCI 18" rack installed last evening. Stoked! I'll found out later today how it works as a canoe transport option.

 

So do any of you guys know what these buttons do I believe it has a info/Select.reset/set up

 

Drive monitor, plug and play gives you more than just the outside temp

https://www.ebay.com/itm/143227457920

 

yes, I added the ebay module as well. If you remove the plastic cover and it has the plug behind, just get the module online and it will plug right in. You will see it displayed on the small digital screen where the clock is

 

Had to take the steering wheel off to swap out the turn signal stalk for the fog light switch so I figured a might as well get a new wheel.

 

i cant even hold a phone straight to take a pic. lol.

finished up leveling out the morimoto's. really happy with how the lights sit now. the left side tracked higher than right out of box about an inch so it was pretty off imo. adjusted both sides to meet in the middle given the warning on the manual adjuster, which indicated if you turn more than three full rotations you may cause issues with ability to adjust. i also cleaned up the left side. connectors/wires were bumping into the battery so it wasn't sitting right and then zip tied everything clean. all good now.

cant wait for that sequoia pro grill to be finished color matched this week. also looking at wrapping the bumpers in maybe satin black. bailing out on color matching them for now.

 

had the same issue with the battery and bundle of wires. After cleaning that up the fit was much better.

 

Losing my mind. Four dead actuators, or so I thought. Replaced two motors. Still not unlocking. About to do other two. Dealership wants $150 to diagnose. Any ideas?

 

Do Line-X Premium on the bumpers. I have it on my bumpers and Bushwacker flares.

 

Nice. How much is that setup?

 

Where did you get the spray liner? Nice job!

 

Ceramic tint...5% all around, and windshield tinted as well.

 

$68 with free shipping, not too bad to help clean up all the wires I expect will make their way under the hood and not braking the bank with a Switch Pro or a Trigger.

https://sdhqoffroad.com/products/sdhq-built-hd-billet-main-battery-terminal-upgrade-kit

 

how much? and is it HEY COP PULL ME OVER DARK?

 

New wheels and tires!

 

Those buttons should allow you to change and configure the information on the readout in the center of your dashboard (just in front of the windshield, under the rear view mirror). You should be able to select mpg, range (based on amount of fuel in tank), outside temperature, etc.

 

470 total. I have 5% all around and the full windshield tinted in clear. That cost included removal of the old 5%.

 

Thanks!

 

Got the truck back from line-x. Turned out they had a problem with their pump. It wasn't mixing the component catalyst properly. They stripped and resprayed the entire bed.