Let’s see pics stock height Pro with 295/70r18

Just mounted up, no issues driving home but I took it easy with the front flaps being super close to the tire until I could remove them. Falken Wildpeak AT3’s.

 

Did you have to use any wheel spacers on the factory wheel with a 12.5 wide?

Also is it safe to go 12.5 on a factory rim? (Only I wide wheel).

 

Yes spacers are a must on the Factory TRD wheels at they are a +60 off set and will need to be distanced from the hub. Currently searching for a new set of lightweight and wider wheels to delete the spacers.

My Toyota dealership but the 12.5s on the truck without hesitation. May not be able to air them down as much in certain situations but they fit and look fine.

Do I rub on the CM a bit in reverse at certain angles, absolutely. Easy fit for that ;-)

 

Dude, you have a sweet truck!

 

Does anyone run 305/70/17 on stock TRD PRO suspension and wheels? Dealer is offering me at cost for a set of tires and want to know if the 305s would work. I currently run 295s and it is good with no rub.

 

^18 inch wheels. My bad

 

I do not believe they would fit but I'm not 100%

 

Has anyone ran BFG KM3s in 295/70 r18 on a stock Pro?

 

Have you had any trouble out of that Lift kit?

 

Toyo 295/70/18. Spacer

 

Black Vs MGM? tough choice!

 

295s? Looks awesome

 

Yes 295/70-R18

 

Falken Wildpeaks AT3 295/70/18. No rub.

 

295/70-18 Nitto Ridge Grapplers. Stock BBS wheels and stock suspension. No wheel spacers either. However, there’s probably a fingerwidth gap between the sidewall and my UCA.

 

For those of you who have switched to 295/70/18 tires, what have you done regarding the spare under the truck?
If you mount 295/70/18 tires on the spare, will it fit in the area reserved for the spare?

 

This can't be stock with just new tires right?

 

295/70/18 Toyo Open Country M/T on stock height and stock bbs wheels. No rubbing, but will add spacers to see what it looks like. May take them off if they look or behave funny...yet to come.

 

Nitto Terra Grapplers 295/70/18 no spacers removed front mud flap and no rubs. The ride is a little squishyier or floatier than before. Probably a little softer over bumps. I didn't notice a power decrease. mileage sucked before and probably does now too. It sure does look better to me with the wheel wells full.

 

Did you use a 3”F and 1”R kit?
How does your ride feel?

 

Toytech shackles(1.5" R), coachbuilder shims(1" F).

 

Hey guys- Just bought a 2020 Pro. I pick it up this week. Already know I’ll be upgrading the wimpy tires on it. For those of you running the Wildpeaks, how bad did they hit your MPG’s and throttle response?

 

Toyo Open Country AT3s in 295/70/18. Everything else stock, and no spacers.

I lost between 0.8 and 1mpg on gas mileage as calculated by the truck's computer in the dash. I would get around 15.8mpg on my normal work commute and now it is right at 15.0 under the same driving and traffic conditions.

 

Those new AT3s look good! How do they ride? Are they as quite as Toyo says they are?

 

They ride great and yes, they're very quiet for an A/T tire. I'm very pleased with them.

 

The ATIII’s look good! Do you have any close up shots of the tires and side shots to see the “poke” if any. Thanks!

 

I fully intended to get spacers, but I think they sit perfect without them. And the tread and sidewall look great...kind of like a BFG KO2 sidewall, but more unique since those are on literally everything. I'm happy with them.