Betty White II Build Finally Begins

It's been about 16 months since I got Betty White II (2018 Platinum) that replaced my totaled Betty White I (2017 Limited).

I was going to leave it alone except for tires for a while, but I couldn't be patient.

After months of procurement I finally have all the pieces ready to go.

My ReadyLift 8" kit is sharing the garage with my new wheels and tires . Assembly is about a week away. Can't wait!!!

 

RIP Betty white! I like were your going with this build cant wait to see results. What fuels are those?

 

What's in the box......

 

Those r looking real MGM! I can dig it. Have you done your BMC to fit those 37s yet?
And do u have a pic of the last truck? Totaled?

 

8" lift with +20 offset will make it real close but the plan is not doing a BMC .

It didn't look bad, but the frame needed to be replaced so they totaled it .it had 4K miles on it ....

 

Oh those looked like a 0 or a negative you might be ok. I went -18 on 7" lift n rubbed with 35s. Had to cut even more for the 38s lol
Dang always sucks to see a wrecked tundra at least you didnt put 2 much money into it before it was wrecked. Gotta find some positive in a bad situation

 

My loaner ride while BW II is in the shop .

 

Finally done.

• ReadyLift 8" with Rear Bilsteins
• Fuel Trophy Wheels - 20x9
• 37x12.5 Yokohama Geolandar MTs

 

Man the fuels look even better on the truck. Turned out really good
Are you gonna get away with not doing the BMC?

 

Yeah exactly what I thought .Look way better in person too. No BMC needed .With 12.5 tires and +20 offset, all they needed to do was time some fender liner. I went with that setup to avoid BMC .

 

I like your wheels. A lift and new wheel and tires makes a big difference.

 

Thanks! Yeah it's unreal

 

Nice height and the wheels are killer. only minor trimming to fit 37s? Job well done

 

Thanks man. Yeah just about an inch of the plastic. I think they could have just heated it, but they just did it without discussing, lol