KC Cyclones installed in the bed

I'd like to install a pair of KC Cyclones in the bed of my truck. I have a couple of questions.....does anyone know how these lights attach...It would be nice to connect them in the bed rail system using someones bed rail pod brackets...like Rago. Second, I have a topper so my factory bed light switch is semi useless as the topper blocks it. Is there an easy way to tie into this circuit so that I can turn these lights on with this switch? Or is it better to just add another switch? Im currently out of switch blanks.

 

They mount using a bolt through the center hole. Mine are attached to the factory rail system using t nuts I purchased from Amazon. Ill add a link later.

 

Get with @mattgecko on his bed lighting, I had one Cyclone light, I didn't like the light output

 

I actually have a set of those T-nuts!

 

I was looking into the Baja designs dome lights with the switch built in for some bed lighting. Mounting them to the bed and not the bed rail. I’m assuming they could be tied into the tail light circuit somehow so there would not be a lot of wire to run. A little more pricey but looks like a good option.