1. Welcome to Tundras.com!

    You are currently viewing as a guest! To get full-access, you need to register for a FREE account.

    As a registered member, you’ll be able to:
    • Participate in all Tundra discussion topics
    • Transfer over your build thread from a different forum to this one
    • Communicate privately with other Tundra owners from around the world
    • Post your own photos in our Members Gallery
    • Access all special features of the site

Y-harness for stock '17 Headlights - anyone make them? (adding bumper recessed driving lights)

Discussion in '2.5 Gen Tundras (2014-2021)' started by HellBent, Jun 18, 2019.

  1. Jun 18, 2019 at 9:01 PM
    #1
    HellBent

    HellBent [OP] Breaker of Things

    Joined:
    May 13, 2019
    Member:
    #30469
    Messages:
    14
    Gender:
    Male
    First Name:
    Brayden
    Texas
    Vehicle:
    2017 SR5 TSS 5.7
    Recently added new bumpers and lights to my '17 TSS (2x LED Fogs and 2x LED Driving Lights -All bumper mounted and recessed)

    I was able to wire the fogs to my factory switch on the stalk, and was considering wiring the driving lights to work with the high beams versus thru the sPOD switches. (I have the front and rear lightbars, rear floods and side floods thru the sPOD)

    Does anyone make a simple Y_harness that would allow me to wire the bumper driving lights directly inline with the factory high beams? I'm running aftermarket LED bulbs, so i don't think the draw for two additional pod style driving LEDs will overload or exceed the pull of the factory halogens i replaced.

    If no harness exists, is there a better way to have the driving pods activate with the high beams vs splicing into the factory leads near the connection at the bulb?

    Thanks for any suggestions!
     

Products Discussed in

To Top