Rubber dust cover

just changed my headlight bulbs to Auxbeam LEDs on my 2019. Did y’all put the rubber dust cover boot back or did you get new ones? The opening is pretty small so I don’t think it would fit the LEDs?

 

I wish I had taken pics. The AuxBeams come apart into two pieces by twisting them about 60 degrees and pulling. They also come apart with an Allen wrench. Don't use the Allen wrench method. Once you get the heat sink part off the rear, the front half will fit through the rubber boot, and then reconnect the heat sink so that it sits outside of the rubber boot and exposed in the engine compartment.

 

Thanks for the response! Gotta re-take it apart and try again!